Supplying batteries since 1952

AFTERMARKET FEBRUARY ‘14

Written on January 21, 2014 at 5:35 pm

Manbat – Real World Battery Solutions

For many years the technology incorporated into the typical car battery remained relatively static, so while the major manufacturers obviously invested in improving the performance of their batteries, they were generally lead-acid batteries designed to cater for large current discharge when starting the engine and subject to continuous charging while the vehicle was running. As far as the workshop is concerned, a traditional battery replacement is a simple and straightforward process.

In contrast, the introduction of Start-Stop vehicles has driven a major change in battery technology. Start-Stop engines have become the preferred route for most of the vehicle manufacturers to enable them to reduce the emissions and fuel consumption of their vehicles and achieve the European Union requirement for fleet average vehicle emissions.

The traditional lead-acid ‘starter’ battery is not suitable for this type of engine and therefore cannot be used. Instead it requires a battery that can deliver the starting power of a traditional automotive battery, with the cyclic (charge, discharge, charge etc.) capacity of a specialist mobility battery. The result is the absorbent glass mat (AGM) battery, which was first developed by VARTA® for whom Manbat is the UK’s largest supply partner. Another alternative is the enhanced flooded battery (EFB), which has similar characteristics to an AGM battery, but is designed for entry-level Start-Stop vehicles that require less electrical capacity.

Technical training is particularly important for these vehicles because the number of potential faults in a Start-Stop system is far greater than for a traditional electrical system. As the engine is switched off as frequently as possible and only restarts when the vehicle pulls away or when the battery’s state of charge drops to a predetermined level, the battery management system (BMS) is extremely complicated.

Therefore the correct testing procedure and fault diagnosis is vital and when the battery needs replacing, technicians cannot go about it as the have traditionally. Instead, as the battery is integrated into the vehicle’s on-board electronics via a BMS or intelligent battery sensor (IBS), the replacement has to be paired with the BMS/IBS, which requires specialist equipment. Without this equipment to assist the technician to ‘introduce’ the battery into the system, the vehicle will at best illuminate error messages on the dash or fail to charge the battery, at worst, simply not start at all.

Another complication comes because there is little guarantee that the battery in a Start-Stop vehicle will be found under the bonnet. Therefore, technicians need to have access to reliable technical data such as TecRMI, to pinpoint the exact location of the battery whether that’s in the boot floor or, as it is in at least one application, beneath the front passenger seat!

Manbat’s ethos is to work alongside its customers in partnership to not only identify and supply the most suitable battery from its portfolio of VARTA, Lucas or Numax, but to also determine the best support programme to help factors in turn support their workshop customers.

Through its long term relationship with VARTA, Manbat has access to both the training, which is delivered by industry specialists eXponentia, and the VSSP 2.0 diagnostic and installation tool that are necessary for workshops to face the battery challenges posed by Start-Stop vehicles and to develop their ability to profit from them.

When it comes to responsible disposal, workshops have to understand their environmental responsibilities and ensure batteries are disposed of legally, as well as benefiting financially from their inherent ‘scrap’ value.

Manbat is a member of the ECOBAT group, which includes specialist waste battery businesses and lead smelter ECOBAT Technologies Ltd, one of the world’s leading suppliers of lead. Through its efficient smelting facilities across the globe, ECOBAT annually converts millions of tons of lead waste into high quality lead ingots, strip, wire and shot. Among its many customers are several of the major battery manufacturers, and some of their brands are subsequently distributed nationally through Manbat’s comprehensive branch network.

The combination of new battery sales and distribution, together with waste battery collection, recycling and the reintroduction of lead into the manufacturing process, means that the ECOBAT group, and therefore Manbat, is able to be exceptionally environmentally aware and is currently the only global company offering a closed recycling loop for lead-acid batteries.

As a result of these combined strengths, allied to its 60-year plus aftermarket heritage, Manbat is fully justified in its claim to be the country’s premier automotive and commercial vehicle power storage product supplier and service provider.

Go Back